~ Anthology ~ Index du Forum ~ Anthology ~
Confrérie du Thorium
 
 FAQFAQ   RechercherRechercher   MembresMembres   GroupesGroupes   S’enregistrerS’enregistrer 
 ProfilProfil   Se connecter pour vérifier ses messages privésSe connecter pour vérifier ses messages privés   ConnexionConnexion 

series of tutorials

 
Poster un nouveau sujet   Répondre au sujet    ~ Anthology ~ Index du Forum -> Guilde Anthology - Confrérie du Thorium -> Recrutement
Sujet précédent :: Sujet suivant  
Auteur Message
burvogue


Hors ligne

Inscrit le: 19 Mai 2012
Messages: 17

MessagePosté le: Lun 11 Juin - 11:43 (2012)    Sujet du message: series of tutorials Répondre en citant

This is the first in a series of tutorials I will be writing on the subject of modifying an existing wholesale corset.. In this tutorial I will discuss how to fit and take out a dart at the bust to reduce the bust size on wholesale corsets. In the example corset shown, I removed a little more than one cup size from the bust. The bust is a low-stress area of a corset, so darts can easily be removed without damaging the durability and strength of most corsets. Keep in mind that sometimes, depending upon the corset and the intended reduction, this modification may not be possible. Check carefully before cutting into your corset.
The first concern when taking in the bust of a corset is to determine where to place darts, and how many to use. It will depend upon the cut of the Corset manufacturer, the amount of space available between bones, and the amount of fabric that is to be taken out. While wearing the corset, pinch out un-boned fabric around the bust until you achieve a good fit. Make sure the darts match on both sides of the corset. I like using binder clips, but long traditional pins work as well. Be sure to mark the lowest point of the dart before removing the wholesale lingerie .
After removing the corset, mark the darts with chalk or pencil and then remove the binder clips or pins. Check both sides of the corset to make sure the darts are in identical positions relative to the boning. Move your marks so they match, but retain the size of the darts. Stitch your final marks with small stitches. Pay particular attention that the stitches at the bottom of the dart are strong. You don’t want any layers of the corset to pull free while working with the dart.
_________________
wholesale corset,wholesale corsets,Corset manufacturer


Revenir en haut
Publicité






MessagePosté le: Lun 11 Juin - 11:43 (2012)    Sujet du message: Publicité

PublicitéSupprimer les publicités ?
Revenir en haut
Montrer les messages depuis:   
Poster un nouveau sujet   Répondre au sujet    ~ Anthology ~ Index du Forum -> Guilde Anthology - Confrérie du Thorium -> Recrutement Toutes les heures sont au format GMT + 2 Heures
Page 1 sur 1

 
Sauter vers:  

Index | forum gratuit | Forum gratuit d’entraide | Annuaire des forums gratuits | Signaler une violation | Conditions générales d'utilisation
World of Warcraft phpBB template "WoWMoonclaw01" created by MOONCLAW/MAËVAH(EU-Sinstralis/EU-Illidan) (v1.05) - http://www.wowcr.net/templates
© World of Warcraft and Blizzard Entertainment are trademarks or registered trademarks of Blizzard Entertainment, Inc. in the U.S. and/or other countries. wowcr.net is in no way associated Blizzard Entertainment.
Powered by phpBB © 2001, 2005 phpBB Group
Traduction par : phpBB-fr.com